3. Installation
To install batteries in the remote control, press up on the battery cover retainer clip and lift off the cover. Install the two AAA batteries with the correct polarity and then replace the cover.
•Make sure that the battery polarities are correct when installing the batteries.
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
•Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the DHD Controller.
•If the effective range of the remote control decreases, or it stops working, replace the batteries with new ones.
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Ambient conditions may possibly impede the operation of the remote control. If this happens, point the remote control at the DHD Controller, and repeat the operation.
3.1
Remote Control
Notes on Batteries
Notes on Remote Control Operation
Runco | 17 |
