Operation

Tip

Note

Use the DHD Controller front-panel keypad to change its IR code. Then, change the code sent by the remote to match as described below.

Do not change the “Type” setting in this menu.

When you change a remote code on the DHD Controller, you must re-program your remote control to send that same code. To do this:

1. Using a straightened paper clip or similar object, press and hold the CODE button on the remote control for approximately three seconds, or until the red LED on the remote lights solid red.

2. Enter a new two-digit code between 00 and 31 inclusive. Include a leading zero for single-digit codes; for example, enter 9 as “09.”

3.The LED turns off to confirm the code change. If you enter an invalid code, the LED flashes for three or four seconds. Try again, entering a valid code.

Analog Out Mode: Select Analog Out Mode from the Service menu to change the characteristics of the analog output signal from the DHD Controller. The choices are RGB-- (separate sync with negative polarity), RGB++ (separate sync with positive polarity) or RGBS (composite sync).

Display Device: The options in the Display Device menu allow you to perform various adjustments at the projector.

Input Source: Select Input Source from the Display Device menu to switch from one DHD Controller output/projector input to the other. Use the or button to select RGB or DVI/HDMI, then press ENTER.

Note

Tip

If the DVI 1 or DVI 2 DHD Controller input is active and the input signal is HDCP-encrypted, the RGBHV output of the DHD Controller is disabled.

Use the serial command DISPLAY [n] (where [n] = 2, 3, 4 or 5) to set the Input Source to RGB or DVI/HDMI, so that the DHD Controller retains this setting after a System Reset. (This is not the

case when you change the Input Source in the Display Device menu.) For more information, refer to Miscellaneous Commands

on page 87.

70

Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual

Page 82
Image 82
Runco VX-80d, VX-40d, VX-50d, VX-60d manual Tip