4 - Troubleshooting the SAGEM F@stTM 1000 modem
4.3.6All LEDs lit
This state indicates that the software has not been correctly downloaded from the PC to the modem. This may happen if the installation procedure is interrupted before it is finished.
Proceed as follows :
!Disconnect then reconnect the USB cable between the PC and the modem.
If the modem still doesn't start up :
!Disconnect then reconnect the power cable from the modem.
If the problem remains, uninstall the drivers and restart the installation of the software as described in § 4.1.
4.4No access to the wide area network
The LEDs should indicate that your equipment is operating normally:
PWR | LINE | USB | DATA |
|
|
|
|
Green, on steady | Green, on steady | Green, on | Green, blinking |
|
| steady | (with data) |
|
|
| Off |
|
|
| (without data) |
!If they do, a link is theoretically set up between your SAGEM F@st™ 1000 and the wide area network.
!If not, refer to section 4.3.
However, you may have problems accessing a WEB page or a remote machine.
User Guide - N56815740110
Page | No reproduction or communication without the written consent of SAGEM SA |
