Samsung CLP-350 manual Solving other problems, Paper feeding problems, Printing problems

Solving other problems

The following chart lists some conditions that may occur and the recommended solutions. Follow the suggested solutions until the problem is corrected. If the problem persists, please call for service.

Paper feeding problems

Condition		Suggested solutions
Paper is jammed	Clear the paper jam. (See "Clearing paper
during printing.	jams" on page 7.1.)
Paper sticks	•	Ensure that there is not too much paper in the
together.		tray. The tray can hold up to 150 sheets of
		paper, depending on the thickness of the
		paper.
	•	Make sure that you are using the correct type
		of paper. (See "Specifications on print
		media" on page 4.2.)
	•	Remove paper from the tray and flex or fan
		the paper.
	•	Humid conditions may cause some paper to
		stick together.
Multiple sheets of	•	Different types of paper may be stacked in the
paper do not		tray. Load paper of only one type, size, and
feed.		weight.
	•	If multiple sheets have caused a paper jam,
		clear the paper jam. (See "Clearing paper
		jams" on page 7.1.)
Paper does not	•	Paper has not been loaded correctly. Remove
feed into the		paper from the tray and reload it correctly.
machine.		Check that the paper guides are set correctly.
	•	There is too much paper in the tray. Remove
		excess paper from the tray.
	•	The paper is too thick. Use only paper that
		meets the specifications required by the
		machine. (See "Specifications on print
		media" on page 4.2.)
	•	Remove any obstructions from inside the
		machine.
The paper keeps	•	There is too much paper in the tray. Remove
jamming.		excess paper from the tray. Check that the
		paper guides are set correctly.
	•	An incorrect type of paper is being used. Use
		only paper that meets the specifications
		required by the machine. (See "Specifications
		on print media" on page 4.2.)
	•	There may be debris inside the machine.
		Open the front cover, remove the imaging unit
		and then remove the debris.

Printing problems

Condition	Possible cause	Suggested solutions
The	The machine is not	Check the power cord
machine	receiving power.	connections. Check the
does not		power switch and the power
print.		source.
	The machine is not	Select a machine name as
	selected as the	your default printer in your
	default printer.	Windows.

Check the machine for the following:

•The cover is not closed. Close the cover.

•Paper is jammed. Clear the paper jam. (See "Clearing paper jams" on page 7.1.)

•No paper is loaded. Load paper. (See "Loading paper" on page 4.4.)

•The toner cartridge is not installed. Install the toner cartridge.

If a system error occurs, contact your service representative.

The connection cable	Disconnect the printer cable
between the	and reconnect it.
computer and the
machine is not
connected properly.
The printer may be in	Check the message on the
manual feed mode	Smart Panel program
and out of paper.	window, add paper to the tray
	and press the Stop button on
	the control panel.
The connection cable	If possible, attach the cable
between the	to another computer that is
computer and the	working properly and print a
machine is defective.	job. You can also try using a
	different printer cable.
The port setting is	Check the Windows printer
incorrect.	setting to make sure that the
	print job is sent to the correct
	port. If the computer has
	more than one port, make
	sure that the machine is
	attached to the correct one.
The machine may be	Check the printer properties
configured	to ensure that all of the print
incorrectly.	settings are correct.

7.4 <Troubleshooting>