Samsung SC-X105L/X110L manual Ventilation

ENGLISH

Notices and Safety Instructions

9.	VENTILATION:
	Slots and openings in the cabinet are provided for ventilation to
	ensure reliable operation of the CAMCORDER and to protect it
	from overheating. These openings must not be blocked or
	covered. Never place your CAMCORDER on a bed, sofa, rug,
	or other similar surface: on or near a radiator or heat register.
	This CAMCORDER should not be placed in a built-in installation
	such as a bookcase or rack unless proper ventilation is provided
	or the manufacturer’s instructions have been adhered to.
10.	POWER SOURCES:
	The CAMCORDER should be operated only from the type of
	power source indicated on the label.
	If you are not sure of the type of power supply at your home,
	consult your appliance dealer or local power company.
	A CAMCORDER is intended to be operated from battery power,

13.OUTDOOR ANTENNA GROUNDING:

If an outside antenna or cable system is connected to the CAMCORDER, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire and supporting structure, grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding to conductors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

See figure below.

or other sources, refer to the operating instructions.

11. GROUNDING OR POLARIZATION:

This CAMCORDER may be equipped with either a polarized

2-wire AC line plug (a plug having one blade wider than the other)

or a 3-wire grounding type plug, a plug having a third (grounding)

pin.

If you are unable to insert the plug fully into the outlet, try reversing

the plug. If the plug still fails to fit, contact your electrician to

replace your outlet. Do not defeat the safety purpose of the

GROUND

CLAMP

ELECTRIC SERVICE

EQUIPMENT

ANTENNA

LEAD IN WIRE

ANTENNA DASCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250, PART H)

polarized plug.

12. POWER-CORD PROTECTION:

Power-supply cords should be routed so that they are not likely to

be walked on or pinched by items placed upon or against them,

paying particular attention to cords or plugs, convenient

receptacles, and the point where they exit from the unit.

NEC NATIONAL ELECTRICAL CODE