Setting Network Protocols

When you first install the machine, all supported network protocols are enabled when you turn the machine on. If a network protocol is enabled, the machine may actively transmit on the network even when the protocol is not in use. This may increase network traffic slightly. To eliminate unnecessary traffic, you can disable unused protocols.

1Press Menu until you see “Network Setup” on the top line of the display.

2 Press the scroll button ( or

) until “Config Network”

D

displays on the bottom line.

 

3Press Enter to access the menu.

4Press the scroll button ( or ) until you see the desired protocol on the bottom line.

5Press Enter.

If you selected “TCP/IP,” assign a TCP/IP address. For details, see page D.8.

If you selected “EtherTalk,” press the scroll button ( or ) to change the setting to “On” (enable) or “Off” (disable). This menu is only available when you machine is SCX- 4520S/4720FS.

If you selected “NetWare”, set the frame type format. For details, see page D.10.

6Press Enter to save the selection.

7Press Stop/Clear to return to Standby mode.

USING YOUR MACHINE ON A NETWORK D.7

Page 284
Image 284
Samsung SCX-4520S, SCX-4720FS manual Setting Network Protocols