SHR-4080P USER’S MANUAL

Motion Detecting

●M.D State

Off : Motion Detection does not operate

On : Motion Detection starts operation.

●Area

Select the Motion Detection zone. It is composed of 45x48 sized Block. You are forbidden to determine 4 block rows(Up/Down/Left/Right) to allow them to be displayed in all monitors.

❿Select All : Selects the whole area.

❿Select One : Selects a block every time. Selection is done by a toggle system.

❿Select Quarter : Split the whole area into 4 pieces, which enables selecting a fourth of the whole area.

❿Clear All : Cancels the whole area.

❿Save & Exit : Saves and exits.

❿Exit : Exits without saving.

●Sensitivity

Determines Motion sensing sensitivity. Sensitivity grade consists of Low ➝ Medium ➝ Very High in the ascending order.

●Alarm-Out

Selects Alarm-Out scope when Motion occurs.

At this moment, this supports 5 Alarm Outs. Choose an alarm-out that you want to synchronize with the current motion channel. Multi-choice is possible.

●Beep-Out

Determines Alarm-Out Duration. Alarm-Out continues for the determined duration. Off/ 3sec/ 5sec/ 10sec/ 20sec/ 30sec/ 1min/ 2min

Video Loss

●Video Loss State

Off : Video Loss does not operate.

On : Video Loss starts operation.

●Alarm-Out

Selects Alarm-Out scope when the current Video Loss occurs.

At this moment, this supports 5 Alarm Outs. Choose an alarm-out that you want to synchronize with the current motion channel. Multi-choice is possible.

●Beep-Out

Determines Alarm-Out Duration. Alarm-Out continues for the determined duration. Off/ 3sec/ 5sec/ 10sec/ 20sec/ 30sec/ 1min/ 2min

5-21

5-22