SHR-4080P USER’S MANUAL
●Event Log Display Window
-Displays the event(alarm, user connection, and setup change) occurring at
Note
[Event Message]
❿Connecting.. : Trying to connect to
❿Connected.. : Succeeded connecting to
❿Connection Failed : Failed in connecting to
❿Disconnected.. : Finished connecting to
❿Setup(Remote) :
❿Setup Start / End (Local) : Start/Finish the Menu screen at
❿Video Loss CH[N] : Video Loss at the N channel of
❿Alarm Detection CH[N] : Alarm issued at the N channel of
❿Motion Detection CH[N] : Motion detected at the N channel of
❿Time Change : Date/Time of
❿Load Factory Default :
❿Network Change :
❿System Shutdown :
❿Hdd Format :
❿Disk Full : No more space in
❿Power Failure Recovery :
❿Play Back Start / End : Start/Finish the image recorded in
❿Record Start / End CH[N] : Recording N channel of
❿Panic Record Start / End : Panic recording at
❿Backup Start/End/Fail/Stop : Backup at
Caution
When Time Change, Load Factory Default, Network Change, System Shutdown, or Hdd Format event occurs, Smart Viewer terminates automatically.
●Screen Split Selection Button
-Small Sized Single / Single / Quad /
-You may change the Split Mode of the screen under monitoring.
●Sequence Mode Button
-Changes the channel to be played at the preset interval.
-The sequence time interval setup follows the procedure of Setup Mode ➝ Viewer
Setup.
- In Single Mode : 1 ➝ 2 ➝ 3 ➝ 4 ➝ 5 ➝ 6 ➝ 7 ➝ 8 ➝ 1 (CH)
-In Quad Mode : 1,2,3,4➝ 5,6,7,8 ➝ 1,2,3,4 (CH)
-In the event of connection with one
Note
If you connected with
-In Single Mode : DVR1:1CH ➝ ...➝ DVR1:8CH ➝ DVR2:1CH ➝ ...➝ DVR1:1CH
-In Quad Mode : DVR1:1,2,3,4CH ➝ ...➝ DVR2:1,2,3,4CH ➝ ...➝ DVR1:1,2,3,4CH
-In
|
