Samsung SHR-4081P manual Callback Settings, 31English

SHR-4081N/P USER’S MANUAL

Note

If you want to connect IP Router with the main body of SHR-4081N/P, you shall designate a port for SHR-4081N/P in the IP Router setup menu.

The SHR-4081N/P main body uses 4 ports for TCP communication and further 160 UDP ports when the procotol type is set to UDP. In addition, if you want to use the DHCP function backed by IP Router to allocate Dynamic IP to the main body of SHR-4081N/P, you shall designate a port for the IP which SHR-4081N/P has been allo- cated by the IP Router setup menu.

If you use IP Router, you are recommended to rather determine IP and Port numbers to be allocated to the main body of SHR-4081N/P from the IP Router setup menu, set the connection mode to Static IP for the main body of SHR-4081N/P, and input the determined IP and Port number in IP Router than use the DHCP function.

Please refer to the IP Router User’s Manual or call the manufacturer to set up IP Router.

Callback Settings

●Callback delivers a callback message to the IP where SmartViewer is already running when an event corresponding to Alarm, Motion Detection, or Video Loss occurs from the set.

●On/Off : Off is the default and On is optional.

●IP Address : IP setup is available only when On/Off is set to On. Sets up the IP address of a PC where SmartViewer is already running.

●Port(UDP) : You may choose a value from 7900 to 7999, increasing by 1. Sets up the port value of Callback Connection set by SmartViewer.

●Retry : You may choose a value from 1 to 20, increasing by 1.

Caution

-Though Callback is set to ON, there will be no Callback message unless Alarm, Motion Detection, or Video Loss is set by Event Record.

-Unless you click the Callback button of SmartViewer, SmartViewer does not receive any Callback message.

5-31English