3GENERAL SET

zA maximum of 9,999,999 alarms can be displayed in the operation display. When this number is exceeded, the alarm count returns to 0000000.

zWhen “ALARM RECORDING” is set to “OFF” on the <ALARM REC MODE SET> screen, the number of alarms and type of alarm recording are not displayed.

zWhen “ALARM RECORDING” is set to “ENABLED” on the <ALARM REC MODE SET> screen, the operation display changes as follows.

z “ALARM” is displayed when alarm video is recorded or played back.

z “PRE” is displayed when pre-alarm video is recorded or played back.

z “ARCHIV” is displayed when video is played back from the archive area.

Setting for control terminal output

Next, specify setting for “CONTROL OUT”.

You can select output from the control terminal (OUTPUT 1/2) on the rear panel.

(1)OUTPUT 1 terminal

z NON REC (default setting): Outputs when recording is stopped.

z VIDEO LOSS:

Outputs when video signal is interrupted.

(2)OUTPUT 2 terminal

z ARCHIVE FULL (default setting):

Outputs when the remaining space of archive area reaches the warning level.

z TIMER REC OUT:

Outputs when timer recording is stopped.

7 Turn the jog dial to select “OUTPUT 1”, and then turn the shuttle dial clockwise.

You will see “NON REC” flash.

 

 

<DISPLAY SET>

 

DATE

: ON

TIME

: ON

QUALITY

: ON

AUDIO

: ON

ALARM COUNT

: ON

ALARM TYPE

: ON

TITLE

: ON

VIDEO LOSS

: ON

NO VIDEO

: ON

 

 

 

CONTROL OUT

 

 

 

 

 

OUTPUT 1

: NON REC

 

 

 

OUTPUT 2

: ARCHIVE FULL

 

8 Turn the jog dial to select “NON REC” or “VODEO LOSS”, and then turn the shuttle dial clockwise.

The cursor moves to “OUTPUT 2”.

 

 

<DISPLAY SET>

 

DATE

: ON

TIME

: ON

QUALITY

: ON

AUDIO

: ON

ALARM COUNT

: ON

ALARM TYPE

: ON

TITLE

: ON

VIDEO LOSS

: ON

NO VIDEO

: ON

 

 

CONTROL OUT

 

 

 

 

OUTPUT 1

: VIDEO LOSS

 

 

OUTPUT 2

: ARCHIVE FULL

 

9 Turn the shuttle dial clockwise.

You will see “ARCHIVE FULL” flash.

10 Turn the jog dial to select “ARCHIVE FULL” or “TIMER REC OUT”, and then turn the shuttle dial clockwise.

11 Press the [EXIT/OSD] button.

The setting is completed and the display returns to the normal screen.

EXIT/OSD

zAfter video loss is detected, the setting can be cancelled by performing either of the following:

(1)Input the video signal.

(2)If no video input is required, use a [CAMERA SELECT] button to select the camera for which video loss was detected and then press the same button for

approximately 3 seconds.

zThe output of “VIDEO LOSS” is provided independently,

even if you specify “OFF” for “VIDEO LOSS” in setting data display. (JP.112)

English

113