Sanyo DSR-5709P 17 Click [SAVE], “SEND MAIL ADDRESS”, 10 Set “IMAGE” to “ON” or “OFF”, 8 Specify “ON” or “OFF” for “USE” under, 6 Set up “SMTP SERVER ADDRESS” and “PORT”

9ADVANCED MENU SET

6 Set up “SMTP SERVER ADDRESS” and “PORT”.

For “PORT”, specify a port number (0 to 65535) for use in SMTP (transmission). (Default setting: 25)

7 Set “USER MAIL ADDRESS” to the e- mail address from which notifications are sent.

8 Specify “ON” or “OFF” for “USE” under“SEND MAIL ADDRESS”.

[Settings] ( indicates default setting)

Setting	Description

OFF	Alarm notification is disabled.

ON	Alarm notification is enabled.

9 Enter the recipient’s e-mail address under “MAIL ADDRESS”.10 Set “IMAGE” to “ON” or “OFF”.

[Settings] ( indicates default setting)

Setting	Description

OFF	An alarm image is not attached to the e-mail.

ON	An alarm image is attached to the e-mail.

11 Specify “ON” or “OFF” for each item under “WARNING”.

You can configure the main unit to send warning notification mail messages when the following problems are detected in the functionality and operation of the main unit.

You can configure the warning notification feature the same way as the alarm notification feature. All settings default to “OFF”; turning “ON” an item causes the main unit to send warning mail when the corresponding condition is detected.

zHDD:

When abnormal condition has occurred in the hard disk drive, or when the hard disc temperature has risen to 70 degrees or more.

zV. LOSS:

The video signal is disconnected.

zFAN:

The fan is faulty.

zNON REC:

The DVR has stopped recording.

zFULL:

Any one of the recording areas on the hard disk has reached the “remaining-space” warning level or has become full.

zPOWER:

The power has turned off and back on again.

zIf you use the “WARNING” function, specify “ON” for “ALARM NOTICE” in Step 4.

zSince “USE” in Step 8 applies to alarm notification, it does not affect the setting for “WARNING”. A warning notification mail message is sent normally when “ON” is set for it.

12 Use the same procedure to set the e- mail addresses of other e-mail recipients.

Up to eight recipient e-mail addresses can be set.

13 Set “SUBJECT” to the subject of the notification e-mail.14 Set “AUTHENTICATION” to select whether authentication is to be performed.

[Settings] ( indicates default setting)

	Setting	Description

	NO USE	User authentication is not performed.

	POP3	POP3 (POP before SMTP) authentication is
	POP3	performed.
		performed.

	SMTP	SMTP authentication is performed.

15 If “POP3” is selected for “AUTHENTICATION”, you need to specify “POP3 SERVER ADDRESS” and “PORT”.

For “PORT”, specify a port number (0 to 65535) for use in POP 3 (reception). (Default setting: 110)

16 If “POP3” or “SMTP” is selected for “AUTHENTICATION”, you need to specify “USER ID” and “PASSWORD”.

17 Click [SAVE].

The setting is saved.

zThe digital video recorder supports the following SMTP authentication:

• CRAM-MD5 • LOGIN

zFor the digital video recorder to perform authentication, the provider must have authentication settings made. Make the authentication settings after confirming the type of authentication supported by the connected provider.

NETWORK SETTINGS

208

English