INSERTING AND EJECTING THE DISK

Be sure to insert the disk before using the digital disk camera. Use only iD PHOTO disks with the iD PHOTO logo mark (_). No other type of disk can be used with this digital disk camera (IDC-1000ZEX, IDC-1000ZE, IDC-1000ZU). Also, before using the supplied disk or any other disk for the first time, always format it first with your digital disk camera (see pages 155, 157).

Inserting the disk

1 Push the EJECT lever in the direction of the arrow.

œThe disk holder opens slightly. Gently open the disk holder in the direction of the arrow given below.

œA protective spacer is placed inside the disk holder at the time of purchase. Remove this spacer if it is present.

Protective spacer

EJECT lever

Disk holder slightly opens

2 Insert the disk into the disk holder.

Label side

œ Insert the disk in the direction of the arrow given (l mark) with its label facing outwards.

œ Be sure to insert the disk all the way in until it is properly seated.

l mark

3 Push the disk holder closed.

Mode display

œ When the disk is inserted, the disk mark in the

panel

 

mode display panel lights.

 

NOTE

If the disk mark turns

œThe disk mark in the mode display panel rotates when a disk is inserted. While the mark is rotating, data on the disk is being read and recording cannot be performed. Wait until the disk mark stops rotating before using the digital disk camera. (The digital disk camera can be turned on while the disk mark is rotating.)

Disk mark

English 30