SETTING UP AND USING THE REMOTE CONTROL

Setting up the remote control

A battery is installed in the remote control at the time of purchase.

1 Pull out the battery insulation sheet.

œ Once the battery insulation sheet is removed, the remote control is ready for use.

Battery insulation sheet

2 Perform the remote control setting at the digital disk camera (see page 124).

œThe remote control setting must be set properly in order to use the remote control to operate the digital disk camera.

œAt the time of purchase, the digital disk camera is already set so that the remote control can be used.

Using the remote control

The remote control must be used within a seven-meter distance from the remote control sensor, between 15 degrees to the left and right on the horizontal. If there is an obstruction between the remote control and its remote control sensor, it may block the signal and prevent operation of the digital disk camera by the remote control. If this is the case, remove the obstruction.

œEach button on the remote control performs the same operation as the button of the same name on the digital disk camera (see page 22).

œWhen an operation is performed with the remote control, the self-timer lamp lights for one second to signal that the signal has been received.

œIf the remote control is located to the front and right of the digital disk camera, the digital disk camera lens may block its signal. If this is the case, change your position.

Remote control sensor

Self timer lamp

Infrared emitter

15˚

 

 

 

 

 

15˚

7 meters

Within

or less

 

15 degrees

 

 

left or right

horizontally

NOTE

œThe signal range of the remote control may be decreased if used under bright sunlight or inverted lighting. This is a characteristic of infrared remote controls and not a malfunction. To reduce problems during use, do not allow such light to enter the remote control sensor.

English 36