Changing the remote control code

This remote control will also work with other Sanyo cameras that can be operated by infrared remote control. Therefore, when more than one camera is present, it is recommended to change the remote control code to ensure that only the intended camera operates when the remote control is used. The remote control code is set to “1” at the time of purchase.

Changing the remote control code from

“ 1” to “ 2”

1 Aim the infrared emitter at the remote control sensor on the digital disk camera.

2 Hold down the CH button and press the W button for more than three seconds.

œThe self-timer lamp lights for one second when the remote control code changes to “2.” Release the buttons on the remote control.

Infrared emitter

CH button CH.

T button T

W button W

Remote control sensor

Self timer lamp

3 Press a button on the remote control and check that the operation was carried out correctly.

œThe remote control code is not lost even if you replace the battery in the remote control.

œIf the remote control codes for the remote control and digital disk camera do not match, operations will not be carried out.

Returning the remote control code to

“ 1”

1 Aim the infrared emitter at the remote control sensor on the digital disk camera.

2 Hold down the CH button and press the T button for more than three seconds.

œThe self-timer lamp lights for one second when the remote control code returns to “1.” Release the buttons on the remote control.

English 38