Sanyo XG-705A Wired LAN Configurations, Connecting to the LAN Line, Network Environment Settings

4. Wired LAN Configurations

Setting procedures and contents differ depending on the LAN installation location. When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN Line

Connect the LAN cable to the LAN connection terminal of the projector.

LAN Connection Terminal

USB

Link Lamp (Orange) Light orange when the terminal is correctly connected to the Network HUB with the LAN cable.

Access Lamp (Green)

Blink green when

exchanging data with the network.

* When the LAN setting is “Off”, the two lamps will

not be on.

LAN Cable

Network Environment Settings

Set the Wired LAN network through the projector menu.

Detailed network settings will be made with browser. Refer to “6. Configurations with Browser” (pp.39–54).

First, complete the settings described in this chapter before performing steps in “6. Configurations with Browser.”

Setting Procedure

1.Turn on the projector and select “Wired” from the input menu of the projector.

The projector’s Link Lamp will be on and the Access Lamp will start to blink. If the “Wired setting” is “Off”, it will not blink. Follow step 2 and 3 to blink the lamp.

2.Select “Wired Setting” in the projector menu, and press the SELECT button.

Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons. (LAN1, 2, and 3 are the factory default setting environments. You can select three different environment among setting LAN1–3. For each setting, refer to the chart on page 31.)

When selecting “Off” in the “Wired setting”, the LAN connection will be cut off. Use the function when disconnecting the projector from the network.

3.Press the Point button then the “Please wait...” message will appear and switching operation will start. Switching will take a while and after completing the operation, the “Ready for use” message will appear. During the switching period, the projector cannot be operated.

26