
10. How to Use the PJ Controller
2. Check the status of the projector
The following items can be checked on the Power & Status screen.
Parameter | Description | ||||
Accumulated | Display the accumulated time of lamp use in hour increment. | ||||
Accumulated | Display the accumulated time of projector use in hour increment. | ||||
Power Status | Display the status of the projector’s lamp as follows: | ||||
| “On”, “Off”, “Standby”, “Power Saver”, “Mode/On cooling | ||||
| down”, “Temperature Error/On cooling down”, “On starting up”, | ||||
| “On power management operating”, “Temperature Error/Standby”. | ||||
Projector Condition | Display the projector’s condition as follows: | ||||
| “Normal”, “Temperature Error”, “Power Failure”. | ||||
Input Status | Display the following input status | ||||
Input | Display the selected input mode. | ||||
Selection | Display the selected input source mode. | ||||
Signal Status | Display the signal status. | ||||
Internal Temperature | Display the detected internal temperature of the projector. | ||||
| The icons A, B, and C stand for the thermal sensors inside the projector. | ||||
| If the internal temperature exceeds the certain point, each icon changes | ||||
| as below and let users know the error. Check the air filters and | ||||
| surrounding area of exhaust and intake vents of the projector. | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Icon A, B, and C are located as follows:
A:Ambient temperature of the projector
B:Ambient temperature of the panel
C:Ambient temperature of the lamp
✳The ambient temperature of the projector may be shown a little higher than the actual temperature.
79