Sharp AR-5520N Creating Margins When Copying Margin Shift, Select the location of the margin

COPY FUNCTIONS

CREATING MARGINS WHEN COPYING (Margin Shift)

The MARGIN SHIFT feature, in its initial setting, automatically shifts the text or image to increase the margin by approximately 10mm.

The location of the margin to be increased can be selected to be either at the left edge or the top of the page.

A Margin A

Original Left Edge

Margin

A

Top Edge

•	This feature cannot be used with the 2 IN 1 / 4 IN 1 feature or rotation copy feature.
		2
Note •	You can also switch between the left margin and the top margin in the system settings. (p.70)
•	The margin width can be changed in the system settings. (p.70)
•	Note that a margin is created by shifting the image, and thus if the image is shifted too far, the edge of the image
	may be cut off.
•	If the ORIGINAL SIZE indicator blinks when margin shift is selected, rotate the original so that it is in the same
	orientation as the blinking ORIGINAL SIZE indicator.

1 Place the original(s).

If you are using the document glass, place the side of the original where you wish to create the margin on the right.

If you are using the RSPF, place the side of the original where you wish to create the margin on the left.

2 If the original is placed on the document glass, select the original size. (p.15)

When using the RSPF, make sure that the same ORIGINAL SIZE indicator as your original size lights up.

3 Press the [MARGIN SHIFT] key ( ).

The MARGIN SHIFT

indicator ( ) lights up.

4 Set the number of copies and other settings, and then press the [START] key ( ).

The copy is delivered to the paper output tray.

•To cancel margin shift, press the [MARGIN Note SHIFT] key ( ) repeatedly until the

MARGIN SHIFT indicator ( ) is off.

•When margin shift is used in combination with automatic two-sided copying, a margin is also created automatically on the back side of the paper directly behind the margin on the front side.

Select the location of the margin

1Hold down the [MARGIN SHIFT] key ( ) until the MARGIN SHIFT indicator ( ) blinks.

The currently selected setting code for the margin position blinks in the display.

1: Left edge 2: Top edge

2Press the [1] key or the [2] key, and then press the [START] key ().

The selected setting code for the margin position lights.

3Press the [MARGIN SHIFT] key ( ).

The MARGIN SHIFT indicator ( ) stops blinking.

33