Setting Up and Using OpenLCR
The following table shows marks related to OpenLCR that may appear in the display.
Mark | Meaning |
OpenLCR has been activated and is ready for use.
OpenLCR cannot be used because the rate data has been erased. Your fax will automatically call
OpenLCR within the next 24 hours to receive new (Blinking) data, or you can download the data manually if you
need to use OpenLCR immediately. See
Downloading (receiving) the rate data manually on page 39.
The rate data in the fax is no longer correct and the fax cannot connect to OpenLCR to obtain new data. See What to do if “E” appears in the display on page 45.
OpenLCR has been temporarily turned off. See
Temporarily turning off OpenLCR below.
Rate data was not yet available when your fax called OpenLCR. Your fax will automatically call OpenLCR again when the rate data is available. Until that time, long distance calls will be routed through your primary carrier.
| Your fax will automatically call OpenLCR within the |
(Blinking) | next 24 hours to learn when correct rate data will be |
available. |
Your fax did not receive rate data because OpenLCR was unable to identify it by Caller ID. To remove the “H” display, press the OpenLCR key followed by #, 1, 8, 4, and #. To receive OpenLCR service, you will need to contact your phone company and allow it to send your Caller ID information when you place calls. After this, register once again with OpenLCR.
42
