Sharp UX-A260 manual Override Ringing, Programming the override code, Answering, Machine

Override Ringing

6 Each time the machine receives an incoming message, it will call your

programmed transfer number. When you answer, you will hear your recorded message telling you that the call is a transfer call. On the dial

pad of your phone, enter , your remote code number (see page 37),

and . The machine will play back your messages.

•You can also perform any of the remote operations described in Remote Operations later in this chapter (see page 37).

Note: When you hang up after a transfer call, the machine will not immediately resume normal operation. If you want the machine to accept calls

immediately after a transfer call, enter twice before hanging up (if you

want to hang up during message playback, first enter 0 and to stop

playback, then enter twice).

Answering	Machine
2.

Override Ringing

This function allows selected callers using a touch-tone telephone to override the answering system's outgoing message and cause the machine to make a special ringing sound, alerting you that they are calling. This is useful when you are near the machine but only want to talk with certain callers, taking all other calls on the answering system.

Programming the override code

To override the answering system, your callers must enter a 3-digit override code from their telephone. This code has been set to "009" at the factory. If you wish to change the code, press the panel keys as shown below.

Important! Make sure the override code is different from the remote code used for remote operations.

1 Press FUNCTION once and	Display:
	once.

T.A.D. SETTING

35