Sharp UX-A260 manual Redial, Automatic redialing, Sending, Faxes, to set the

Sending a Fax by Automatic Dialing

Redial

You can automatically redial the last number dialed. This procedure can be used to send a fax or make a phone call.

1 If you are sending a fax, load the document(s).

•	RESOLUTION/	to set the
	If desired, press RECEPTION MODE

resolution and/or contrast.

READY TO SEND

2 Press once. <REDIAL> appears in the display, followed by the last

number dialed. Make sure the number that appears is the number you wish to dial.

3 If you are sending a fax, press START/MEMORY . Dialing and transmission begins.

If you are making a phone call, lift the handset. Dialing begins.

Note:

If a fax transmission is unsuccessful and DOCUMENT JAMMED appears in the display, remove the document as explained on page 89. (This may occur if the other fax machine doesn’t respond properly when you attempt to send the document.)

Automatic redialing

If you use automatic dialing (including Direct Keypad Dialing) to send a fax and the line is busy, the fax machine will automatically redial the number. The fax machine will make three redial attempts at an interval of five minutes. During this time, RECALLING will appear in the display, followed by a two-digit number assigned to the fax job. You will not be able to dial any other locations while the message appears.

Sending	Faxes
3.

55