8.12.98

I_KAP03.FM5

Gigaset 2060isdn, Inland:

A30853-X210-B101-1-19

Basic settings

Setting point-to-multipoint

.t Service

tLocal op.

tMulticell op.

Point to multipoint is the default access mode of your Gi- gaset 2060isdn. Use the procedure described here to configure the point-to-multipoint mode and define opera- tion as local or multicell (in other words mobile units con- figured for use with one or more base stations).

When configured in this way your Gigaset 2060isdn is compatible only with a point-to-multipoint access in- stalled by your network provider. For more information on multicell operation, page 81.

The comfort mobile unit is idle. You will be prompted to

Ženter the system code in the course of this procedure (default code: “0000”).

tMeaning: see footnote

 

t

System settings

t

Configuration

t

Point to MP.

After confirming - and thus activating - “Point to MP.”, se- lect:

For operation with one base station (single-cell mode, de- fault)

or

For operation with more than one base station.

If you select multicell operation:

Enable or disable calls from and to multiple base stations.

It is not advisable to enable calls between inter- nal users across multiple base stations unless your Gigaset 2060isdn is connected to a private branch exchange.

The PBX must support this internal traffic. For more information on point-to-multipoint opera- tion page 17 and page 84

tmeans: browse with u

Z or u NEXT

and press x

OK

to confirm

23

Page 23
Image 23
Siemens 2060isdn manual Basic settings Setting point-to-multipoint, Local op Multicell op