Sigma S2Ca, S2Ba warranty 3162-4

Dulcodes UV-Desinfektionsanlage Product description S2Ba/S2Ca

The liquid end can continue to operate in emergency mode, i.e. full operating pressure, no leakage, even after diaphragm rupture, until the diaphragm has been replaced. We offer two versions of the S3Ca with diaphragm rupture sensor:

•After a working diaphragm rupture, the pump stops and an ”error“ message/diaphragm sensor signal is given.

•After a working diaphragm rupture, the pump will continue to run. An ”error“ message/ electrical signal is given.

A function plug is supplied which allows the pump to continue operating after a fault has occurred (diaphragm rupture, failure of the diaphragm rupture sensor).

WARNING

¥EX-pump only: Installations in potentially explosive atmospheres must be inspected by an Òaccredited qualifiedÓ person. This applies in particular also for intrinsically safe electrical circuits.

¥EX-pump only: observe documents supplied with the sensor!

IMPORTANT

¥In the case of the S2Ba, the customer should install a diaphragm rupture signal monitor and/or ensure that the pump will stop after a diaphragm rupture.

¥In the event of diaphragm failure, a contact signal is triggered as from 2 bar system backpressure.

¥Exact pump delivery can no longer be guaranteed after failure of the working diaphragm.

¥The auxiliary diaphragm, Item 148, is a wearing part and must be replaced after failure of the working diaphragm. The diaphragm rupture sensor lens, Item 156, should be replaced after every diaphragm rupture.

111	103
112	147
118	148
203	149
204	150
200	201
100	159
110	156
117	157
101	155
113	158
114	160
	104
115	161
116	162
FM 130	163

Identcode Type: 12050, 12090, 12130, 16050, 16090, 16130
FM 350	Fig. 8
Identcode Type: 04350, 07120, 07220	3162-4

ProMinent® Page 23