Dulcodes | |
|
|
NOTE
The tightening torque of the liquid end screws should be rechecked after 24 hours of operation.
The tightening torques of the liquid end screws should be checked every 3 months for the
PVT material version.
Fig. 12
GUIDELINE ON VALVE INSTALLATION
In the case of suction problems during installation, place the valves on a firm surface and tap the PTFE ball seat disk lightly with a brass rod and a hammer weighing about 300 g. Let the valves operate in the wet state.
approx. 300 g
Brass rod 9 mm diam. x approx. 200 mm
Fig. 13
NOTE
¥If suction problems with the pump or leakage at the overcurrent valve are encountered, first clean the ball and the ball seat disc.
¥For media containing particles larger than 0.3 mm it is absolutely essential to install a filter in the suction line.
Page 32 | ProMinent® |
