Sigma S2Ba, S2Ca Settings, Dulcodes UV-Desinfektionsanlage, Factor, Pulse sequential, Increase

Settings Dulcodes UV-Desinfektionsanlage

In the “contact - identity code: external with external pulse control” you can enter the number

of pulses after which a stroke should be carried out. “Contact - identity code: external with external pulse control” is intended for small dosing quantities.

￿￿￿

Continuous display

P

Set ￿￿￿￿￿	P	Contact
		Set ￿￿
		Mem

P

￿￿￿Contact￿

Mem

Set

P

The number of strokes per pulse depends upon the factor, which you can enter. This allows you to vary to a certain extent the input pulses by a factor of 1.01 to 99.99 and/or reduce by a factor of 0.01 to 0.99:

“Number of strokes activated = factor x number of input pulses”

Examples		Factor	Pulse (sequential)	Stroke number (sequential)
	Increase	1	1	1
		2	1	2
		25	1	25
		99.99	1	99.99
		1.50	1	1.5 (1 / 2)
		1.25	1	1.25 (1 / 1 / 1 / 2)
	Reduction	1	1	1
		0.50	2	1
		0.10	10	1
		0.01	100	1
		0.25	4	1
		0.40	2.5 (3 / 2)	(1 / 1)
		0.75	1.33 (2 / 1 / 1)	(1 / 1 / 1)

Explanation of increase	At a factor of	1	For every 1 pulse, 1 stroke is activated
	At a factor of	2	For every 1 pulse, 2 strokes are activated
	At a factor of	25	For every 1 pulse, 25 strokes are activated
Explanation of decrease	At a factor of 1		After 1 pulse, 1 stroke is activated
	At a factor of 0.5		After 2 pulses, 1 stroke is activated
	At a factor of 0.1		After 10 pulses, 1 stroke is activated
	At a factor of 0.75		After 2 pulses, 1 stroke is activated,
			then after 1 pulse, 1 stroke is activated,
			then after 2 pulses, 1 stroke is activated etc.

Page 48 ProMinent®