![](/images/new-backgrounds/1061342/6134255x1.webp)
BOBBIN SETTING
Be sure to use only SINGER Class 15 bobbins in this machine.
A.REMOVING THE BOBBIN
1. Pull the bobbin cover latch to the right and remove the bobbin cover.
2. Lift up the bobbin from the machine.
B.SETTING SPOOL OF THREAD ON
SPOOL PIN
1. Pull up the left end of spool pin and set the spool of thread on spool pin so that the thread unrolls from the front of the spool.
2.Set the spool cap on spool pin as far as it will go. a. Reverse spool cap direction according to the
size of spool.
b. Use the small spool cap when you use cross wound thread. Leave small opening between cap and spool as illustrated.
C.WINDING THE BOBBIN
1. Hold thread in both hands and hook thread to the guide from front opening.
2. Bring thread towards the rear of the machine and pass through the thread guide from left to right.
3. Bring thread to the right and pass thread through the thread guide from rear side. Pass thread under tension disc in counter clockwise direction.
4. Insert thread through hole in bobbin and place the bobbin on bobbin winder spindle. Push bobbin to the right to engage bobbin winder. LCD
will indicate the bobbin winding mode.
5. Hold the end of the thread and start the machine by pressing the start/stop button or pressing the foot controller pedal.
6. After the bobbin winds a few turns, stop the
machine by pressing the start/stop button or releasing the foot controller pedal. Cut the thread
near hole.
7. Start the machine again.
8. The bobbin winding will stop automatically when bobbin is full. Release the foot controller pedal.
9. Push the bobbin and spindle to the left.
10. Remove the bobbin from the spindle and cut the
thread.
28