SMC Networks SMC8612XL3 F 1.0.1.3 manual Setting Passwords

INITIAL CONFIGURATION

those available at the Privileged Exec level and allow you to only display information and use basic utilities. To fully configure the switch parameters, you must access the CLI at the Privileged Exec level.

Access to both CLI levels are controlled by user names and passwords. The switch has a default user name and password for each level. To log into the CLI at the Privileged Exec level using the default user name and password, perform these steps:

1.To initiate your console connection, press <Enter>. The “User Access Verification” procedure starts.

2.At the Username prompt, enter “admin.”

3.At the Password prompt, also enter “admin.” (The password characters are not displayed on the console screen.)

4.The session is opened and the CLI displays the “Console#” prompt indicating you have access at the Privileged Exec level.

Setting Passwords

Note: If this is your first time to log into the CLI program, you should define new passwords for both default user names using the “username” command, record them and put them in a safe place.

Passwords can consist of up to 8 alphanumeric characters and are case sensitive. To prevent unauthorized access to the switch, set the passwords as follows:

1.Open the console interface with the default user name and password “admin” to access the Privileged Exec level.

2.Type “configure” and press <Enter>.

3.Type “username guest password 0 password,” for the Normal Exec level, where password is your new password. Press <Enter>.

2-6