-128
Example

ip route

Use this command to configure static routes. Use the no form to remove
static routes.
Syntax
ip route {destination-ip netmask | default} {gateway} [metric metric]
no ip route {destination-ip netmask | default | *}
•destination-ip – IP address of the destination network, subnetwork, or
host.
•netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
•default – Sets this entry as the default route.
•gateway – IP address of the gateway used for this route.
•metric – Selected RIP cost for this interface. (Range: 1-5, default: 1)
•* – Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
• You can configure up to 2000 static routes.
• Static routes take precedence over dynamically learned routes.
• Static routes are included in RIP updates periodically sent by the router.
Example
This example forwards all traffic for subnet 192.168.1.0 to the router
192.168.5.254, using the default metric of 1.
Console(config)#ip routing
Console(config)#
Console(config)#ip route 192.168.1.0 255.255.255.0 192.168.5.254
Console(config)#