Sony 507D, HKDV-503 Digital audio system, Analog audio Cue track, Input connectors, Analog output

Digital audio system

Digital audio signal format (CH-1 to CH-4) Sampling frequency

	48 kHz (synchronized with video)
Quantization	20 bits/sample
Wow and flutter	Below measurable level
Headroom	Selectable settings: 20, 18, 16, 15,
	14, 12, and 9 dB
Emphasis	T1=50 µs, T2=15 µs (on/off
	selectable in recording mode)
Analog output
A/D quantization	20 bits/sample
D/A quantization	20 bits/sample
Frequency response
	20 Hz to 20 kHz +0.5 dB/–1.0 dB
	(0 dB at 1 kHz)
Dynamic range	More than 95 dB (at 1 kHz,
	emphasis on)
Distortion	Less than 0.05% (at 1 kHz,
	emphasis on, reference level1))
Crosstalk	Less than –90 dB (at 1 kHz,
	between any two channels)

Analog audio (Cue track)

Frequency response

	90 Hz to 12 kHz ±3 dB
S/N ratio	More than 45 dB (at 3% distortion
	level)
Distortion	Less than 2% (T.H.D at 1 kHz
	reference level1))
Wow and flutter	Less than 0.2% rms

Input connectors

HD SDI INPUT

BNC (1 + 1 INPUT MONITOR) HD SDI (1.485 Gbps) (conforms to

SMPTE 292M/BTA S-004B)

SDTI (OPTION) IN

(when the optional HKDV-506A is installed)

BNC (1)

SDTI (270Mbps)

REF. IN
	BNC (2 + 2 loop-through)
HD	Trilevel SYNC
	0.6 V p-p, 75 Ω , sync negative
SD	Black burst

0.286 V p-p, 75 Ω , sync negative

AUDIO INPUT (AES/EBU)

BNC (2 + 2 loop-through) CH1/2 and CH3/4

AES/EBU format, unbalanced

AUDIO INPUT

XLR 3-pin, female (5) CH1, 2, 3, 4 and CUE

LOW OFF: –60 dBu, high impedance, balanced

HIGH OFF: +4 dBu, high impedance, balanced HIGH ON: +4 dBm, 600 Ω termination, balanced

TIME CODE IN

XLR 3-pin, female (1)

0.5 to 18 Vp-p, 10 kΩ , balanced

Appendix

..........................................................................................................................................................................................................

1) Reference level: + 4 dBm

Note

The ANALOG AUDIO INPUT CH1/2/3/4/CUE connectors, ANALOG AUDIO OUTPUT CH1/2/3/4/CUE connectors, and TIME CODE IN/OUT connectors (XLR 3-pin) have

gender conventions for input and output connectors in Japan which are opposite to those everywhere else in the world. If using this unit with non-Japanese specification equipment, use male/female adaptors.

Appendix A-3