Sony HKDV-507, HKDV-503, HKDV-506A, HKDV-502 Char Warning, Remain Time, TC Conversion, Original TC

Item number	Item	Settable range	Function
627	CHAR WARNING	[off]	When item 626 is set to anything other than time data only,
	DISPLAY at dual	on	this item specifies whether warning messages flash on the
	line mode		second line or not.
			off: Warning messages do not flash.
			on: If a warning message exists, it flashes.

			Notes
			• Messages that have been cleared are not displayed. For
			more information about clearing warning messages, see
			“Clearing warning messages” on page A-12.
			• When there are multiple warning messages, each
			message flashes twice before it is replaced by the next
			message.
628	REMAIN TIME	[off]	Sets whether to display remaining time on the tape in
	DISPLAY	10min	superimposed charecter position.
		on	off: Do not display remaining time.
			10 min: Display remaining time when it is 10 minutes or
			less.
			on: Always display remaining time.

			Notes
			The remaining time on the tape is not displayed when no
			cassette is inserted. The remaining time is not also
			displayed until the VTR finishes detecting the diameter of
			the wound tape and estimating the remaining time
			immediately after the cassette is inserted.
630	TC CONVERSION	[off]	Specifies whether or not to convert the 24 frames time code
	at 25F off-speed	on	to the 25 frames time code when off-speed playing back the
	PB		cassette tape recorded in the 24F mode with the 25F mode.
			off: Does not convert the 24 frames time code to the 25
			frames time code.
			on: Converts the 24 frames time code to the 25 frames time
			code.

				Note
				This setting is only active when the field frequency is 25 Hz.
631	ORIGINAL TC	[off]	When item 630 is set to “on,” this setting specifies whether		Appendix
	display	on	the 24-frame time code is displayed or not on the control
			panel of the VTR before conversion.
			off: The 24-frame time code is not displayed before
				conversion.
			on: The 24-frame time code is displayed before conversion.
				The type of time code type displayed is specified by item
			603.
632	JUMPING TC	[–3H]	When the 24-frame time code is converted to 25-frame time
	select	–2H	code, this setting specifies the loopback point (JUMPING
			TC) with respect to the reference point for conversion
		–1H
			(STARTING TC).
		+1H	–3H: The JUMPING TC is set 3 hours before STARTING
		+2H		TC.
			–2H: The JUMPING TC is set 2 hours before STARTING
		+3H
				TC.
		0H	–1H: The JUMPING TC is set 1 hour before STARTING TC.
			+1H: The JUMPING TC is set 1 hour after STARTING TC.
			+2H: The JUMPING TC is set 2 hours after STARTING TC.
			+3H: The JUMPING TC is set 3 hours after STARTING TC.
			0H: The JUMPING TC is set 1 frame before STARTING TC.

Appendix A-33