Sony HKDV-502, HKDV-503 Changing the superimpose position, To display remaining time on the tape

4-3 TC Menu

Chapter 4 Menu Settings

To display remaining time on the tape

Use the 628.REMAIN TIME DISPLAY to display remaining time on the tape.

off: Do not display remaining time.

10min: Display remaining time when it is 10 minutes or less.

on: Always display remaining time.

When remaining time is 23 minutes.

T C R . 2 3 : 5 9 : 4 0 : 1 8 * R 2 3

When remaining time is five minutes.

T C R . 2 3 : 5 9 : 4 0 : 1 8 * R 5

When remaining time is 100 minutes or over.

T C R . 2 3 : 5 9 : 4 0 : 1 8 * R - -

Examples of remaining time display

Changing the superimpose position

The superimpose position can be set to 16 different positions in the horizontal directions (0-15) and 24 different positions in the vertical directions (0-23).

1,3 2

1 Press the ALT/[F7] (CHARA H-POS) button to change the horizontal position and the [F8] (CHARA V-POS) to change the vertical position. The setting display part is lit.

2 Use the [<] and [>] buttons to change the value. The + and – buttons can also be used.

3 Press the ALT/[F7] (CHARA H-POS) button or the [F8] (CHARA V-POS) button. The positions are set and the setting display disappears.

The positions are also set if another menu is selected.

4-3-13 Setting the VITC Insertion Line (VITC POS-1/POS-2)

VITC signals can be inserted at two positions in the output signal from the HD-SD converter.

1,3 2

Setting the VITC insertion line (VITC POS-1/POS-2)

1 Press the ALT button, then the [F9] (VITC POS-1) button.

The setting display part is lit.

2 Press the G or g button to change the value. You can also use the + or – button.

3 Press the [F9] (VITC POS-1) button.

The data setting is completed and the setting display disappears. Switching to another menu also completes the setting display disappears.

Following the same steps but using the [F10] (VITC POS-2) button, VITC can be inserted on another line.

4-32Chapter 4 Menu Settings