Chapter 4 Menu Settings

4-4 CUE Menu

To copy time data of a cue point to another cue point specified in the CUE menu

1 Press the ALT/[F4] (COPY to CUE) buttons.

A message appears (in the control panel display) requesting confirmation of the copy operation.

To cancel the copy operation

Press the CLR button.

2 Press the [F4] (COPY to CUE) button while pressing down the SFT button.

The time data of the cue point is copied to the cue point indicated in the CUE menu.

Changing Mrk data

Use the cursor buttons to move the cursor to the line with the mark attribute to be changed, and then press the [F6] (MARK) button. Or, move the cursor directly to the mark attribute to be changed, and then press the [F4] (CHANGE DATA) button. In both cases, each press of the button changes the attribute as follows: OK nNG nKP (keep temporarily) nblank (no attribute).

Changing the recording starting point setting

Use the cursor buttons to move the cursor to the recording starting point section. Then press the [F4] (CHANGE DATA) button. Each press of the button turns the setting on (the @ indication appears) or off (the @ indication disappears).

Entering and modifying IN/OUT point data

You can use either the ENTRY button or the numeric buttons to enter and modify IN/OUT point data.

To enter or modify IN/OUT point data using the ENTRY button

21

1Use the cursor buttons to move the cursor to the IN/OUT section on which the current time code is to be entered or replaced.

To move the cursor using the numeric buttons

With the cursor specifying Time, Mrk, IN, OUT or the recording starting point section in the TELE FILE menu display, enter the line number using the numeric buttons. Then press the [F9] (CUENUM POINT) button. The cursor will move to the line specified by the numeric buttons.

2Press the IN button (to enter IN point data) or OUT button (to enter OUT point data) while pressing down the ENTRY button.

The current time code is entered as the IN/OUT point data or it replaces the existing IN/OUT point data.

Note

If the cursor is not on the IN/OUT section when pressing the IN/OUT button while pressing down the ENTRY button, the current time code is entered as the Time data or it replaces the existing Time data. When pressing the ENTRY button only, the Time data is entered or replaced regardless of the cursor position.

4-46Chapter 4 Menu Settings

Page 88
Image 88
Sony HKDV-503 Changing Mrk data, Changing the recording starting point setting, Entering and modifying IN/OUT point data