Connections and | Chapter5 |
Settings for Editing |
Note
Production of some of the peripherals and related devices described in this chapter has been discontinued. For advice about choosing devices, please contact your Sony dealer or a Sony sales representative.
Connection Using i.LINK
Use in a Nonlinear Editing System (AV/C Connection)
With this unit connected to a nonlinear editing system by
HDV/DV connectors, you can input and output signals in HDV or DVCAM/DV format, and use remote control of this unit.
The following figure shows an example of the connections.
|
|
|
|
|
|
| AC IN |
|
|
VIDEO |
|
|
|
|
| AUDIO |
|
|
|
|
|
| IN |
|
|
| |||
IN |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| 1/3 | 2/4 |
REF.VIDEO | Y/CPST | VIDEO OUT | (SUPER) | AUDIO |
|
|
| ||
IN(SD/HD) |
| CPST | OUT |
|
|
| |||
|
|
|
|
|
|
|
| 1/3 | 2/4 |
IN | OUT1 | OUT2 SDI | OUT1 | OUT2 | IN | AUDIO I/O (AES/EBU) | OUT | ||
|
|
|
|
| 1/2 |
| 3/4 | 1/2 | 3/4 |
TC IN | OUT | MONITOR |
|
|
| HDV/DV | REMOTE | ||
|
| AUDIO |
|
|
|
|
| ||
HDV/DV
i.LINK cable (not supplied)
i.LINK (IEEE 1394) connector
Computer
Note
The i.LINK output from this unit is automatically switched between DV/DVCAM format and HDV format, according to the input selection and the format recorded on the tape. Since the i.LINK stream is different for HDV or DV/ DVCAM, switching causes a bus reset on the i.LINK interface, which may cause a problem with some connected nonlinear editors.
In such cases, set OPERATIONAL FUNCTION >INTERFACE SELECT: i.LINK FORMAT to i.LINK INPUT, and select the i.LINK input format to match that to be used.
To connect for DVCAM/DV format
To transfer video and audio signals recorded in DVCAM/ DV format or HDV format to a nonlinear editing system in DVCAM/DV format, make the following settings.
Here the data recorded in HDV format is output down- converted to DVCAM/DV format.
Computer settings | Settings on this unit |
Install editing software | Remote control switch: i.LINK |
supporting the DVCAM/ |
|
INTERFACE SELECT >i.LINK | |
DV format | OUTPUT menu item: DV (SP) or |
| |
| DVCAM (see page 83) |
|
|
| For capture: |
| Switching i.LINK input signal: |
| i.LINK:DVCAM or i.LINK:DV |
| Also, set the OPERATIONAL |
| FUNCTION >AUTO EE SELECT: |
| STOP and STANDBY OFF menu |
| items to PB. |
|
|
| For writing back: |
| Switching i.LINK input signal: |
| i.LINK:DVCAM or i.LINK:DV |
| Also, set the OPERATIONAL |
| FUNCTION >AUTO EE SELECT: |
| STOP and STANDBY OFF menu |
| items to EE. |
|
|
Notes
•The nonlinear editing system requires editing software (not supplied) to support the DV or DVCAM format.
Editing for Settings and Connections 5 Chapter
Connection Using i.LINK | 55 |
|
|