INSTALLING THE BACKUP BATTERIES
Your system requires four AA batteries to provide backup power for a few hours if AC power fails. The backup batteries do not power all the system's features. For the best performance and longest life, we recom- mend RadioShack alkaline batteries.
If the power fails but the backup batteries are installed and have power, all data and sys- tem information is retained and network com- munication is restored.
Cautions:
•Use only fresh batteries of the required size and recommended type.
•Before replacing the batteries, discon- nect all telephone lines from your sys- tem.
•Do not use rechargeable batteries.
1.Turn the unit over, press the tab on the battery compartment cover, then lift off the cover.
2.Place the batteries in the compartment over the ribbon as indicated by the polarity symbols (+ and
3.Replace the cover.
Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.
Cautions: Always remove old or weak bat- teries. Batteries can leak chemicals that can destroy electronic parts.
Note: If the power is out and your phone is operating on battery power, the phone will automatically switch to pulse dialing. If you phone line does not support pulse dialing, you will not be able to dial.
Battery Power Levels
When the batteries have enough power (over 5.6V), no icons appear.
When the batteries become weak (5 to
5.6V), 
appears.
When the batteries are too weak (less than
5V) or not installed, 
appears.
CONNECTING THE AC ADAPTER
Cautions:
The supplied AC adapter sup-
!plies at least 11 volts AC and delivers at least 600 mA.
Using an adapter that does not meet these specifications could damage the telephone or the adapter.
•To prevent damage to the telephone or the adapter, plug the adapter into the telephone before plugging the adapter into an AC outlet.
1.Insert the AC adapter's barrel plug into the adapter jack on the bottom of the telephone.
2.Route the adapter's cord through the groove on the bottom of the phone, then plug the adapter into a standard AC out- let.
ATTACHING THE HANDSET
Plug one end of the supplied coiled cord into the jack on the telephone's handset. Plug the other end into the jack with the handset mark on the left side of the telephone's base.
Note: Your local RadioShack store sells a variety of longer coiled handset cords which can be useful if your telephone is mounted on a wall.
Installation | 13 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
