ˆPreparation
On initial
Important: In this manual, the word “select” means you must press the button below the desired option.
SETTING UP THE STATIONS
1.At the INTIAL SETUP screen, select
START.
2.Select NEXT. SET STATION 11 appears.
3.Repeatedly select CHANGE until the desired extension number
If the number is already used for another station, an error beep sounds and nn NOT AVAIL appears (nn = the station number). Select CHANGE to select another number.
4.Select SAVE. STATION nn SET appears.
5.Select NEXT. The time setting menu appears.
6.Use the keypad to enter the hour and minutes in two digits. Precede a single- digit hour or minute with 0 (01, 02, 03 and so on).
If you make a mistake, select BACK to
7.Select SAVE, then NEXT. The AM/PM selection menu appears.
8.Select CHANGE to toggle between AM and PM, then select NEXT. The date set- ting menu appears.
9.Use the keypad to enter the month (01– 12) and day
If you make a mistake, select BACK to
10.Select SAVE, then NEXT. The day set- ting menu appears.
11.Select CHANGE until the correct day of the week appears. Then select NEXT.
INITIAL SETUP COMPLETE appears.
12.Write the name or section for each extension on the supplied extension card and slide it into the slot on the bot- tom of the phone.
Note: INPUT CORRECT DATA appears if you enter an invalid date or time. Check and correctly enter the data.
VERIFYING THE STATION AND LINE CONFIGURATIONS
1.Select LINE 1. The line indicator lights green and the speakerphone indicator lights red. The station ID appears to indi- cate the station is in use.
2.Using another phone, dial the telephone number for Line 2. The line indicator for Line 2 flashes red. If the indicator does not flash, check for correct installation.
3.Repeat Step 2 for Lines 3 and 4.
If the indicators for all the lines flash, you have successfully installed this station.
Preparation | 15 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
