Sprint Nextel SP7084 Memory Operation, Storing a Name and Number in Memory, Entering a Pause

43-5708.fm Page 23 Monday, September 18, 2000 7:56 AM

ˆMemory Operation

You can store up to 20 phone numbers and names in memory, then dial a stored number by specifying the memory location.

Each stored number can be up to 16 digits, and each name can be up to 14 characters.

STORING A NAME AND NUMBER IN MEMORY

1.Press PROGRAM.

2.Select PHON then NEXT until AUTO-

DIAL SETUP appears.

3.Select ENTER.

4.Repeatedly select NEXT until the desired memory location (01–20) appears. Then select EDIT. NUMBER (or a number if the location has been stored previously) appears.

Note: Locations 01 to 10 are the upper memories; locations 11 through 20 are the lower memories. To access the lower memories, press LOWER, then the desired autodial button (see “Dialing a Stored Number” on Page 24).

5.Use the keypad to enter the stored num- ber, up to 16 digits. If the number is entered incorrectly, select < to move the cursor left, then DEL to remove the dig- its. Use the keypad to re-enter the cor- rect digits.

6.Select NEXT. Use the keypad to enter the name, up to 14 characters. Press the key once to display the first letter on that key, twice to display the second let- ter, three times to display the third letter, or four times to display the fourth letter. Pressing the key repeatedly cycles through all the characters on the key.

To add a space, press 1.

7.Select NEXT to move the cursor to the right.

8.Repeat Steps 6 and 7 until the name is entered, then select SAVE to store your entry.

9.Repeat Steps 4 through 8 to store addi- tional numbers.

10.Press PROGRAM to exit.

Use the memory card to keep track of your stored numbers. Lift the card’s cover off, write down the names and numbers, then snap the cover back into place.

Entering a Pause

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an out- side number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to con- nect.

To enter a 2-second pause, press HOLD/ PAUSE. The display shows P for pause entry. You can add more pause entries for a longer pause.

Editing Stored Numbers

1.Follow Steps 1–4 under “Storing a Name and Number in Memory.”

2.Select EDIT. The stored number appears. To change it, select < to move the cursor left, then DEL to remove the digits. Then use the keypad to enter the new digits.

Memory Operation 23