Figure 19.8.0 - RINGER OUTPUT menu

19.8.1 Transmitting a DSC Position Send Call

Pre-Programmable Calling

Using the Individual directory to transmit a position send call.

1.Select the chart page and press the [CALL] key. The “DSC Operation” menu Tabs will appear at the bottom edge of the display.

2.Press the [POSITION SEND] soft key to show “DIRECTORY” popup window on the display.

3.Move the ShuttlePoint knob to the up or down or turn the Channel knob to select the “Individual” you want to contact, then press the [ENT] key.

4.Press the [ENT] key again to send your position to the selected vessel.

Manual Calling

1.Select the chart page and press the [CALL] key. The “DSC Operation” menu soft keys appear below the display.

2.Press the [POSITION REQUEST] soft key to show “DIRECTORY” popup window on the display.

3.Move the ShuttlePoint knob to the up or down or turn the Channel knob to select MANUAL, then press the [ENT] key to appear “MMSI INPUT” popup window on the display.

4.Enter the MMSI number from the keypad. You may enter the MMSI number by moving the ShuttlePoint knob. Move the ShuttlePoint knob

to up or down to scroll through numbers (0-9) and move the ShuttlePoint knob to the right to move one space to the right.

5.If a mistake was made entering in the MMSI number move the ShuttlePoint knob to the left until the wrong number is selected, then press the correct key or move the ShuttlePoint knob to up or down to correct the entry.

6.When finished entering the MMSI number, press the [ENT] key.

7.Press the [ENT] key again to send your position to the selected vessel.

CPV550

Page 115