Standard Horizon CPV550 10.1MAKING ADDITIONAL ROUTES, 10.2CREATING A ROUTE USING MARKS ON THE CHART PAGE, NAME, [ENT], [CLR], [ENT], ROUTE, [ENT], [ENT], [ENT], [CLR], [RTE], [RTE]

Figure 10.0 - Route Report

11.When finished press [ENT] to save.

12.Press [CLR] to show the Chart page.

10.1MAKING ADDITIONAL ROUTES

To create another Route the GPS Chart Plotter must be told that you want to create a second Route.

1.Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT].

2.Move the ShuttlePoint knob to highlight ROUTE and press [ENT].

3.Move the ShuttlePoint knob to highlight SELECT and press [ENT].

4.Move the ShuttlePoint knob to an open Route number example Route 2.

5.Press [ENT].

6.Press [CLR] to show the Chart page is shown.

7.To create the new Route, follow the steps in Creating a Route using Waypoints or Marks sections.

10.2CREATING A ROUTE USING MARKS ON THE CHART PAGE

To create a Route containing Marks you first must create the Marks and show them on the Chart page.

1.Move the ShuttlePoint knob over the top of a Mark that you wish to be the starting point in the Route and press [RTE].

2.Next move the ShuttlePoint knob until the cursor is over the Mark that you want to be the next leg in the Route.

3.Press [RTE]. You will notice a bearing line joins the first and second Mark which means these Marks are selected into the Route.

4.Repeat steps 3 and 4 until all Marks are entered into the Route.

NOTE

At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific name follow the remaining steps.

5.To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT] or move the ShuttlePoint knob to the right.

6.Move the ShuttlePoint knob to highlight ROUTE and press [ENT].

7.Move the ShuttlePoint to highlight REPORT and press [ENT].

8.Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will be shown.

Page 56 CPV550