Standard Horizon CPV550 10. ROUTES, 10.0CREATING A ROUTE USING WAYPOINTS, NAME, [RTE], [RTE], [ENT], ROUTE, [ENT], [ENT], [ENT], [MENU], REPORT, CPV550, USER POINTS

10. ROUTES

The GPS Chart Plotter has the capability to store 50 Routes with a maximum of 50 Waypoints each.

A Route can consist of Waypoints or Marks. The difference is when a Route is made using Waypoints and the Route is deleted the Waypoints are also deleted. However if a Route is made of Marks and the Route is deleted the Marks stay in memory.

10.0CREATING A ROUTE USING WAYPOINTS

1.On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint in the Route.

2. Press [RTE], you will notice the Starting Waypoint will be placed under the cursor.

3.Move the ShuttlePoint knob to the second Lat/Lon of the next leg in the Route.

4.Press [RTE]. You will notice another Waypoint is shown under the cursor and a line joins the starting Waypoint to the Second Waypoint.

Figure 10.0 - Creating a Route using Waypoints

5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.

NOTE

At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific name follow the remaining steps.

6.To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT].

7.Move the ShuttlePoint knob to highlight ROUTE and press [ENT].

8.Move the ShuttlePoint knob to highlight REPORT and press [ENT].

9.Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will be shown.

10.Move the ShuttlePoint knob up/down to change the characters and left/right to select a different character in the Routes Name.

CPV550 Page 55