2.6.0Output Sentences

GLL, VTG, BWC, WCV, APA, APB, HDG, BOD, XTE, RMA, RMB, RMC, GGA, HSC, DBT, DPT, MTW, VWH, MWV

2.6.1Input Sentences

VHF Radio - DSC, DSC

Radar - TLL

AIS Receiver - VDM

2.6.2Cables

The CPV550 is supplied with two accessory cables used with AUX 1 and I/O connectors on the rear panel. Below is the pin out and connection examples of the cables.

2.6.3I/O Connector Table

Pin

Wire Color

Description

Connection Example

Additional Information

1

Black

---

No Connection

 

2

Red

---

No Connection

 

3

Green

NMEA Common

Common for NMEA devices

 

4

Blue

NMEA Input Port 1

Conncect to output of NMEA device

Default is NMEA0183

5

Brown

NMEA Output Port 1

Conncect to intput of NMEA device

Default is NMEA0183 with GLL. RMB, RMC, and XTE sentences

6

Gray

NMEA Input Port 2

Conncect to output of NMEA device

Default is NMEA0183

7

White

NMEA Output Port 2

Conncect to intput of NMEA device

Default is NMEA0183 with GLL. RMB, RMC, and XTE sentences

8

Yellow

NMEA Output Port 3

Connect autopilot

Default is NMEA0183 with APA. APB, XTE, COG, and BOD sentences

2.6.4AIS Receiver Setup

Connect the NMEA output and NMEA common wires of the AIS receiver to the Port 1 (blue and Green wires. For the Chart Plotter to show AIS targets the NMEA in/out Connections menu must be changed to AIS 38400 as shown below.

1.From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press the [ENT].

2.Move the ShuttlePoint knob to highlight ADVANCED SETUP and press the [ENT] key.

3.Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press the [ENT] key.

4.Move the ShuttlePoint knob to highlight PORT1 INPUT and press the [ENT] key.

5.Move the ShuttlePoint knob up/down to select AIS 38400 and press the [ENT] key.

6.Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.

CPV550

Page 21