2.4GPS ANTENNA
2.4.0Mounting the GPS WAAS Smart Antenna
The CPV550 is supplied with a 12 Channel GPS WAAS Smart antenna. This antenna is designed to be mounted on a base, installed on an extension or even flush mounted. Choose a location for the antenna that has a clear view of the sky and is not located within 3 FT of Radar or other transmitting antenna. Ensure there are no major obstructions or fixtures in the immediate proximity to the antenna. The antenna relies on direct “line of sight” satellite reception. If you are unsure of the chosen location, temporarily mount the antenna in the desired location to verify correct operation. If mounted close to Radar, and after the CPV550 has a fix, turn on the Radar to ensure the CPV550 holds the fix (use the GPS Status Page).
2.4.1Mounting on a Pole
The thread used on the antenna is an industry standard (1 inch 14TPI) used on a wide range of mounting brackets. Due to the manufacturing process of these mounting brackets you may see some slop when tightening down the antenna to the bracket. This is no concern however as the antenna must be tightened until the antenna stops rotating.
NOTE
The antenna cable can be cut and spliced to ease installation. Care must be taken when reconnecting the antenna cable to protect from water and corrosion.
2.4.2Flush Mounting
NOTE
Before drilling holes, it is recommended the antenna be positioned where the location is planned to be drilled, cable connected to the CPV550 and the CPV550 turned on to ensure a GPS Fix is received.
1.Remove the threaded base from the antenna dome.
2.To ease installation a flush mounting template for the antenna has been included.
3.Apply the mounting template sticker to the area that was verified for GPS reception.
4.Then, drill out the 0.63” (16 mm) and 0.16” (4 mm) holes, and remove the template.
5.Insert the cable into the 0.63” (16 mm) hole and route to the CPV550.
6.Apply a small amount of RTV to the under side of the antenna.
7.Place the antenna and then screw it into place using the screws. In some cases the screw may not be long enough, if this happens simply apply more RTV to the underside of the antenna to glue it into place.
CUTTING TEMPLATE
0 4 mm [0.155"]
0 16 mm [0.63"] or greater
0 4 mm [0.155"]
0 4 mm [0.155"]
GPS OVERALL SHAPE
Figure 2.3.2 - Installing the GPS WAAS Smart antenna
CPV550 | Page 19 |