Standard Horizon CPV550 7.1.1Cursor Vs. Home Mode, 7.1.2Cursor and Menu selection speed, MENU, [ENT], [ENT], CHART, [ENT], [ENT], [CLR], [MENU], Home mode, Cursor Mode, CURSOR SPEED

7.1.1Cursor Vs. Home Mode

Cursor Mode

When the cursor is shown on the Chart page, this is called Cursor mode.

In Cursor mode the position of the vessel will not stay in the center of the page and will move right off the edge of the screen (as your boat moves) Cursor mode allows you to pan around and look at areas on the map. In this mode your can also measure distance and bearings from your current position.

NOTE

To change from Cursor mode to Home mode press [CLR].

Home mode

When the ships icon is only shown on the Chart page (cursor is not shown) you are in Home mode. Now as the ship moves through the water the vessels position will be kept in the center of the display.

7.1.2Cursor and Menu selection speed

The GPS Chart Plotter allows you to control the speed the Cursor moves when the ShuttlePoint knob is pressed. To change the speed:

Figure 6.1.2 - Cursor Speed menu

1.From the Chart Page, press [MENU] twice. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move the ShuttlePoint knob to the right.

2.Move the ShuttlePoint knob to highlight CURSOR SPEED and press [ENT] or move the ShuttlePoint knob to the right.

3.The menu now shows two selections, CHART and MENU which allows the Cursor Speed to be selected to High, Medium or Low on Chart page or within the menus.

4.With CHART or MENU selected, press [ENT] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to the desired setting and press [ENT] or move the ShuttlePoint knob to the right.

5.Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint knob to the left a few times.

6.Move the cursor on the Chart page and see if the speed is to your liking.

Page 42 CPV550