Star Micronics NX-1000 Set vertical tab stops every II lines, Set vertical tab stops in channel

Cancels all current vertical tab stops and sets new vertical tab stops at lines nl, n2, etc., where nl, n2, etc. are numbers between 1 and 255. A maximum of 16 vertical tab stops can be set. The tab stops must be specified in ascending order; any violation of ascending order terminates the tab stop list. Standard termination is by the < 0 r control code. The vertical tab stops are set in terms of the current line spacing and do not move if the line spacing is changed later.

Set vertical tab stops every II lines

IModel	ASCII				I Decimal			I	Hexadecimal		I
Both	< ESC >	“e”	“ 1”	n	27 101	49	n	IB	65	31	n
	<ESC >	“e”	<I>	n	27 101	1	n	1B	65	01	n

Cancels all current vertical tab stops and sets new tab stops every n lines, where n is between 1 and 127.

Set vertical tab stops in channel

,

Mode ASCIIDecimalHexadecimal

<ESC>	“b” nO nl	27	98 n0 nl	1B 62	n0 nl
Both	...<O>	n2	0	n2	00
n2

Cancels all current vertical tab stops in channel no, (where no is between 0 and 7) and sets new vertical tab stops in this channel. (A channel is a

set of vertical tab stops selected by the < ESC > “/” command.) See < ESC > “B” for parameters nl, n2, ... < 0 > .

Select vertical tab channel

Mode	ASCII			Decimal	Hexadecimal
Both	< ESC >	“/”	n0	27 47 n0	1B 2F n0

Selects a set of vertical tab stops designated by a channel number (no) from 0 to 7. The tab stops in each channel are set by < ESC > “b”.

Vertical tab

Mode	ASCII	Decimal	Hexadecimal
Both	<VT>	11	OB

Feeds the paper to the next vertical tab stop and moves the print position to the left margin. Performs a line feed if no vertical tabs are set, as at power-up. Feeds to the top of the next page if vertical tabs are set but the current line is at or below the last vertical tab stop.

75