Star Micronics NX-1000 manual Set top of page at current position, Set page length to n lines

Set top of page at current position

Model	ASCII		Decimal	Hexadecimal	I
IBM 1	<ESC>	“4”	27 52	IlB 34	I

Sets the current position as the top-of-page position. Note that this can also be done from the control panel.

Set page length to n lines

Mode	ASCII			Decimal	Hexadecimal
Both	<ESC>	“C”	n	27 67 n	1B 43 n

Sets the page length ton lines in the current line spacing, where n is between 1 and 127 in Standard mode or between 1 and 255 in IBM mode. Changing the line spacing later does not alter the physical page length. The current line becomes the top of the page.

Set page length to n inches

IModel I	ASCII			I	Decimal		I	Hexadecimal	I
Both	<ESC>	“C” CO>	n	27	67	0 n	1B	43 00	n

Sets the page length to n inches, where n is between 1 and 22 in Standard mode or between 1 and 127 in IBM mode. The current line becomes the top of the page.

Set top margin

ASCII			Decimal	Hexadecimal
< ESC >	“c”	n	I 27 99 n	IlB 63 n

Sets the top margin to (n - 1) lines, where n is between 1 and 255. Printing begins on the nth line on the page. The power-up default is n = 1, giving no top margin.

Set bottom margin

Mode	ASCII			Decimal	Hexadecimal
Both 1	<ESC>	“IV	n	1 27 78 n	IlB 4E	n

Sets the bottom margin to n lines, where n is between 0 and 127 in Standard mode or between 0 and 255 in IBM mode. The bottom margin is reset when you change the page length.