Configuring the Digi One IA Ethernet modules
Before the modules can be used, they each need to be programmed with the IP Address. You will need to have the module wired to 24VDC and plugged into your Ethernet network. If you have a separate 24VDC power supply you can program these modules without installing them into the blender and they will retain the programmed address.
Locate your A3 CD and run Setup.exe that is found under the “Digi Software folder” (this can be found by double clicking on “my computer”, then the icon for the CD, then the “Digi Software” folder, and finally the Setup.exe icon). After setup starts you will see the following screen:
Click Next.
Page 33
