9-4-20 REAR BRACKET AND STATOR
Mount the diode stack on the rear bracket and combine them with the stator. Connect the connecting terminals according to the circuit chart.
Note: See 8.2 “Diode stack”
Fig.
(1)Holding the rear bracket and stator, fit them to the inlet port of the front bracket. Match the mounting hole of the rear bracket and that of the rotor bear- ing, and softly strike the outside periphery of the rear bracket with a plastic hammer.
Note: Set the cable so that it comes out from the bottom of the stator. Be careful not to position it between the stator and the rear bracket.
(2)Wind th e st at or cover around the stator.
Fig.
(3)Fit the screw boss, located in three places of the front bracket, with the boss in three points of the rear bracket, and clamp them with three M6 bracket bolts.
Torque for the rear bracket: 55 .^u75
(4)Put the grommet in the groove of the rear bracket and secure the wire.
Note: Fix the wire from the stator and diode stack with the clamp at the bottom of the groove.
