Sun Microsystems 280R manual What Next, Close and then lock the system front doors

7.Press carefully on the center of the drive and watch as the handle begins to close. The drive handle begins to close as the drive engages its backplane connector.

8.Press the handle toward the drive until the latch closes, securing the drive in place.

9.Repeat the procedure for the other drive (if necessary).

If you have finished removing and installing disk drives, remove the antistatic strap.

10.Close and then lock the system front doors.

Turn the keyswitch to the Locked position. This locks the system front doors preventing access to the power supply(s) and to the disk drive(s) installed in the system.

11.Restart the system and return the keyswitch to the Locked position. For more information, see “How to Power On the System” on page 40.

What Next

When you restart the system, be sure to run power-onself-test (POST) and OpenBoot Diagnostics tests to verify that the system functions correctly with the new parts you have just installed. You do not have to perform a reconfiguration boot with FC-AL drives. For additional information, see:

■“How to Isolate Failures Using Power-On Self-Test (POST)” on page 179

■“How to Isolate Failures Using OpenBoot Diagnostics” on page 181

If you need to remove a disk drive, see:

■“How to Remove a Disk Drive” on page 122

Chapter 5 Using and Servicing Internal Storage Devices 127