Sun Microsystems 280R manual A Shell Tool window on the Sun server, type

3. In a Shell Tool window on the Sun server, type:

hostname% tip hardwire

connected

The Shell Tool window is now a tip window directed to the Sun server ttyb port.

Note –Use a Shell Tool, not a Command Tool; some tip commands may not work properly in a Command Tool window.

4.At your UltraSPARC system, enter the Forth Monitor so that the ok prompt is displayed.

Note –If you do not have a video monitor attached to your UltraSPARC system, connect the UltraSPARC system ttya serial port to the Sun server ttyb serial port and turn on the power to your UltraSPARC system. Wait for a few seconds, and press Stop-a to interrupt the power-on sequence and start the Forth Monitor. Unless the system is completely inoperable, the Forth Monitor is enabled, and you can continue with the next step in this procedure.

5.If you need to redirect the standard input and output to the ttya serial port, type:

ok ttya io

There will be no echoed response.

6.Press Return on the Sun server keyboard. The ok prompt shows in the tip window.

Note –Do not type Stop-afrom a Sun server being used as a tip window to your UltraSPARC system. Doing so will abort the operating system on the server. (If you accidentally type Stop-a, you can recover by immediately typing go at the ok prompt.) Typing ~# in the tip window is equivalent to pressing Stop-aat the UltraSPARC system.

7.When you are finished using the tip window, end your tip session and exit the window.

184 Sun Fire 280R Server Owner’s Guide • January 2001