2.Plug in the TPE cable to the appropriate RJ-45 connector. You should hear the connector tab snap into place.

RSC TPE connector

System TPE connector

3.Plug in the other end of the cable to the TPE outlet port in the wall or the floor.

Caution Ensure that you plug this connector into the TPE RJ-45 port and not any phone RJ-45 port. You can damage your TPE equipment if you use the incorrect port. You should hear the connector tab snap into place.

See your network administrator if you need more information about how to connect to your network, and to which port in the wall.

What Next

If you are installing your system, complete the installation procedure. Return to:

“How to Install the Sun Fire 280R Server” on page 15

If you are installing additional interfaces to the system, then you need to configure those interfaces; see:

“How to Add an Ethernet Interface” on page 54

58 Sun Fire 280R Server Owner’s Guide • January 2001

Page 86
Image 86
Sun Microsystems 280R manual RSC TPE connector System TPE connector