What to Do

1.Open the rack door (if necessary). Release the decorative panel retaining screws securing the server to the rack, and extend the server from the rack. Position one person on each side of the system, facing the system glides.

When you are both in position, verify that your helper understands what to do with the system after you release it and remove it from the rack. Also agree on a route to follow, and visually inspect it for potential safety hazards (for example, cables on the floor, other people working in the vicinity, and so on).

2.Locate the flat spring catch shown in the following figure.

Each person should visually locate one of the two flat spring catches that release the system from the rack glide. One catch is attached to each inner glide, as shown in the following figure.

Chapter 2 System Setup 31

Page 59
Image 59
Sun Microsystems 280R manual What to Do, Locate the flat spring catch shown in the following figure