10.To assign a static IP ADDRESS, type the following commands in exact order: ELOM:
set /SP/network IPSource=static
set /SP/network IPAddress=xxx.xxx.xxx.xxx set /SP/network Netmask=xxx.xxx.xxx.xxx set /SP/network Gateway=xxx.xxx.xxx.xxx Where xxx = IP address numbers
ILOM:
set /SP/network/ pendingipdiscovery=static set /SP/network/ pendingipaddress=xxx.xxx.xxx.xxx set /SP/network/ pendingipnetmask=xxx.xxx.xxx.xxx set /SP/networks/ pendingipgateway=xxx.xxx.xxx.xxx set /SP/networks/ commitpending=true
Where xxx = IP address numbers
Example 2
To change the service processor (SP) static IP address to a DHCP IP address using the serial connection (system management port), perform the following steps:
1.Connect a terminal (or a PC running terminal emulation software) to the server serial port.
2.Ensure that the server hardware is installed and cables are inserted.
3.Verify that your terminal, laptop, PC, or terminal server is operational.
4.Configure the terminal device or the terminal emulation software running on a laptop or PC to the following settings:
■8,N,1: eight data bits, no parity, one stop bit
■9600 baud
■Disable hardware flow control (CTS/RTS)
■Disable software flow control (XON/XOFF)
5.Connect a null serial modem cable from the server’s back panel serial management to a terminal device (If not connected already).
See FIGURE
6.Press Enter on the terminal device to establish a connection between the terminal device and the LOM SP. The prompt appears.
Chapter 3 Setting Up the Sun Fire X4150 Server | 39 |
